IWP Interior Primer

Eureka Paints IWP is an Acrylic Base interior primer recommended as a base coat for internal painting. It is water thinable & formulated to seal the base surface, so as to accept the topcoat easily & to protect the
substrate & give an elegant look to the walls

Key Features

• ŸŸEureka Paints IWP is very easy for application as it requires no curing before or after application
• ŸŸAs the drying time is very less, it increases the speed of work enabling timely completion
• ŸŸBeing Acrylic base it is compatible to the acrylic emulsion applied over it
• ŸŸBeing waterbase it saves the extra cost of thinner for dilution

Substrate Suitability

Eureka Paints IWP is compatible to the following substrates -
P O P, Gypsum, Gypsum board false ceilings, Asbestos sheets, Concrete, Plaster etc.

How To Use

Surface Preparation

• ŸScrap the surface properly before applying the primer
• ŸEnsure that the substrate to be painted is free of any dirt, dust, oil, grease, any algal/fungal growth or any other type of contamination.
• ŸIn case of pr-paitned surfaces - loose old paint etc. should be thoroughly removed

Application System

Product	Application Tool	Thinner	Dilution % (by vol)	Application Viscosity (sec)	Recoat* Period (hrs)
Sand the surface lightly with Amery paper 180 and wipe clean with cloth
Eureka Paints PolyPlast Acrylic Putty	Putty Knife, Spray	Water	As required	N.A.	4 hrs
Sand the surface lightly with Amery paper 180 and wipe clean with cloth
Eureka Paints IWP Interior waterbase Acrylic Primer	Brush, Spray	Water Water	65-70% 70-75%	30-40 20-25	3-4hrs 3-4hrs
Sand down with Emery paper 320 and wipe clean
2 Coats of recommended paint system

* Recoat period is quoted for 25° C at 50% relative humidity - may vary under different conditions.

Technical Data

Covering**	200 - 225 sft per ltr for per coat
Drying Time	Touch Dry 1 Hr | Hard Dry 4 - 6 Hrs
Colour / Finish	White / Smooth
Recommended DFT per coat	15 - 20 microns per coat depending on the condition of surface
Specific Gravity Kg/ltr	1.45 +/- 0.05
Viscocity KU	142
PH Value	8 to 9
Hardness	4H
Shelf Life	24 months when stored in cool & dry place in original sealed container
Top Coat	Compatible to all the existing top coating systems (viz. Distemper, Plastic, Luster, etc)

** Covering mentioned is for application above Eureka PolyPlast Acrylic putty, however the actual covering may vary depending on the condition of surface & method of application

Precautions

• Do not over thin or overextend the brush
• ŸStir well & strain before use

Pack Sizes & Shade Range